STB625 MEINL Kuhglocke 6, 25" steel model

The Laserworld CS-2000RGB FX adds three grating effects to the CS-2000RGB: line grating, burst grating and radial grating.Together with the approx. 200 patterns stored on the laser, these effects offer a variety of combinations for impressive illumination of small to medium-sized locations. The grating effects make the projected patterns appear as if they were displayed by many projectors at the same time. The resulting extensiveness allows for effects that could not be achieved in any other way.But that's not everything the Laserworld CS-2000RGB FX has to offer:The Laserworld CS-2000RGB FX is a full color RGB laser system a total output power of up to 2'000 mW and a minimum output power of 1'600 mW. The red laser source at 635 nm has an output power of 250 mW, the green DPSS at 532 nm of 250 mW and the royal-blue laser source at a wavelength of 445 nm has an output power of 1'100 mW. The laser sources ensure powerful laser beams. The projector has good beam specifications with a beam diameter of about 3 mm and beam divergence of 2.0 mrad. The galvo system has a scan speed of up to 30 kpps.Pattern size and the sensitivity of the microphone can be set by two rotary buttons on the rear side of the housing. Through DMX, in the automatic mode as well as in the sound-to-light mode about 200 preset patterns, like waves, tunnels, circles etc. can be projected in different colors and in various speed. If the automatic mode is active, the pre-programmed patterns run without assistance and in the music mode, the laser system projects according to the sound.Next to the modi mentioned above, this laser projector provides a master-slave-mode. Show lasers of the same series (slave projectors), connected via DMX cable to a main projector (master projector) project the same patterns like the master projector.The Laserworld CS-2000RGB FX is computer controllable through a professional ILDA interface. Thus own or pre-programmed lasershows, logos, texts or own graphics and animations can be shown in combination with a laser control software (e.g. Showeditor or Showcontroller).Total Power typical: 2'000 mW Guaranteed power: 1'600 mW Power Red: 250 mW / 635 nm Power Green:250 mW / 532 nm Power Blue:1'100 mW / 445 nm Beam Specifications: ca. 3 mm / 2 mrad Laser Sources: Diode, DPSS Laser Laser Class:4 Operation Modes:stand-alone, sound-to-light, DMX, ILDA, Master-Slave Scanner:galvo system, 30 kpps@4° Scan Angle max.:40° Basic Patterns:ca. 200 (layers, tunnels, fences, waves, etc.) + three gratings: line, burst, radial Accessories:power cable, manual, interlock connector, key Power Supply: 85 V - 250 V AC Power Consumption:120 W Dimensions: 190/274/160 mm Weight: 4.75 kg