ADJ LED RC2 remote control

Remote Control for :

Flat PAR CWWW9

Flat PAR CWWW18

Flat PAR QA5

Flat PAR QA5X

Flat PAR QA12

Flat PAR QA12X

Flat PAR QWH5

Flat PAR QWH5X

Flat PAR QWH12

Flat PAR QWH12X

Mega QA PAR 38

VBAR PAK

VPAR PAK

Mega Tripar Porfile Plus

Blackout - Pressing this button will blackout the fixture.

Auto run - This button will run an automatic program. You can control the speed of the Auto

Run by pressing the SPEED button first and then pressing the “+” and “-” buttons.

PROGRAM SELECTION - This button will let you access one of the seven static color selections.

Pressing this button and then press the “+” or “-” to navigate through

the seven programs.

FLASH - This button will activate the strobe effect. You can control the flash rate by pressing the

“+” and “-” buttons. Press this button again to exit strobe mode.

SPEED - Press this button and use the “+” & “-” buttons to adjust the speed of the Auto run.

DMX MODE - This button will let you select which DMX mode you want to use. Some fixtures will

come with different DMX channel modes. This button will switch between the different

modes. Please see your corresponding fixture in this user manual to find out

about your DMX modes, values, and traits.

SOUND ACTIVE - This button activates sound active mode. Sound active mode will not work for

outdoor LED lights.

SLAVE - This designates the fixture as a slave fixture in a master/slave configuration.

SET ADDRESS - Press this button to set the DMX address. Press this button first, then press the

numbers to set the address. Example: DMX Address 1 Press “S001”

DMX Address 245 Press “S245”

R G B A W- Press either one of these buttons, and then press the “+” and “-” to adjust the brighness.

“+” and “-” - Use these buttons to adjust the flash rate, speed of the Auto Run, dimming, and program

selection.